Mazda CX-3: Audio Set [Type A (non-touchscreen)] / Voice Recognition Learning Function (Speaker Enrollment)

Mazda CX-3 (2015-2025) Owner's Manual / Interior Features / Audio Set [Type A (non-touchscreen)] / Voice Recognition Learning Function (Speaker Enrollment)

The voice recognition learning function enables voice recognition appropriate to the characteristics of the user's voice. If the recognition of the voice input commands to the system is not adequate, this function can largely improve the system's voice recognition of the user. If your voice can be recognized sufficiently without using this function, you may not realize the added benefit of the function. To register your voice, the voice input command list must be read out. Read out the list when the vehicle is parked. Perform the registration in as quiet a place as possible. The registration must be performed completely. The required time is a few minutes. The user needs to be seated in the driver's seat with the voice input command list for voice recognition learning visible.

Voice Recognition

In this section, the basic operation of the voice recognition is explained. Activating Voice Recognition To Activate the Main Menu: Press the pick-up button or talk button with a short press...

When voice recognition learning is done for the first time

Press the pick-up button or talk button with a short press. Say: [Beep] “Voice training” Prompt: “This operation must be performed in a quiet environment while the vehicle is stopped...

Other information:

Mazda CX-3 (2015-2025) Owner's Manual: Immobilizer System


The immobilizer system allows the engine to start only with a key the system recognizes. If someone attempts to start the engine with an unrecognized key, the engine will not start, thereby helping to prevent vehicle theft. If you have a problem with the immobilizer system or the key, consult an Authorized Mazda Dealer...

Mazda CX-3 (2015-2025) Owner's Manual: Tilt/Slide Operation


The moonroof can be opened or closed electrically only when the ignition is switched ON. Before leaving the vehicle or washing your Mazda, make sure the moonroof is completely closed so that water does not get inside the cabin area. After washing your Mazda or after it rains, wipe the water off the moonroof before operating it to avoid water penetration which could cause rust and water damage to your headliner...

Categories

Speedometer

The speedometer indicates the speed of the vehicle.

NOTE

(Analog speedometer type)

If a few seconds have elapsed after switching the ignition off, the needle may deviate. However, this does not indicate a problem.

Speed Unit Selector (Digital Speedometer)(Some models)

In some countries, you may have to change the speed units between km/h and mph.

read more

 
Copyright © 2025 www.macx3.net