Mazda CX-3: Warning/Indicator Lights / Warning Lights
These lights turn on or flash to notify the user of the system operation
status or a system
malfunction.
*1 The light turns on when the ignition is switched on for an
operation check, and turns off a few seconds later or
when the engine is started. If the light does not turn on or remains turned on,
have the vehicle inspected at an
Authorized Mazda Dealer.
*2 The light turns on continuously when the parking brake is
applied.
These lights turn on or flash to notify the user of the system operation
status or a system
malfunction.
*1 The light turns on when the ignition is switched on for an
operation check, and turns off
a few seconds later or when the engine is started...
Other information:
To temporarily cancel the system, use one
of these methods:
Slightly depress the brake pedal.
(Manual transaxle)
Depress the clutch pedal.
Press the OFF/CAN switch.
If the switch is pressed when the
vehicle speed is 25 km/h (16 mph) or higher, the system reverts to the
previously
set speed...
The tachometer shows engine speed in
thousands of revolutions per minute (rpm).
CAUTION
Do not run the engine with the tachometer
needle in the RED ZONE.
This may cause severe engine damage.
Type A
Type B
NOTE
When the tachometer needle enters the
STRIPED ZONE, this indicates to the
driver that the gears should be shifted
before entering the RED ZONE...
Categories
The fuel gauge shows approximately how
much fuel is remaining in the tank when
the ignition is switched ON. We
recommend keeping the tank over 1/4 full.
If the low fuel warning light illuminates or
the fuel level is very low, refuel as soon as
possible.
If inconsistency in engine performance or
stalling occurs due to low fuel level
conditions, refuel the vehicle as soon as possible and add at least 10 L (2.7 US
gal,
2.2 Imp gal) of fuel.
Refer to Taking Action.
read more