Mazda CX-3: Specifications / Identification Numbers
Vehicle Identification Number
The vehicle identification number legally identifies your vehicle. The number is on a plate attached to the cowl panel located on the left corner of the dashboard. This plate can easily be seen through the windshield.
Motor Vehicle Safety Standard Label (U.S.A. and Canada)
Chassis Number
Open the cover shown in the figure to check the chassis number.
Vehicle Emission Control Information Label (U.S.A. and Canada)
Tire Pressure Label
Engine Number
Specifications
Engine
Electrical System
*1 The spark plugs provide the SKYACTIV-G its optimum
performance. Consult an Authorized Mazda Dealer for details.
CAUTION
When cleaning the iridium plugs, do not use a wire brush...
Other information:
Mazda CX-3 (2015-2025) Owner's Manual: Fuel-Filler Lid and Cap
WARNING When removing the fuel-filler cap, loosen the cap slightly and wait for any hissing to stop, then remove it: Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness if ingested. Fuel spray is released when there is pressure in the fuel tank and the fuel-filler cap is removed too quickly...
Mazda CX-3 (2015-2025) Owner's Manual: Replacing a Wheel
WARNING Always use wheels of the correct size on your vehicle: Using a wrong-sized wheel is dangerous. Braking and handling could be affected, leading to loss of control and an accident. CAUTION A wrong-sized wheel may adversely affect: Tire fit Wheel and bearing life Ground clearance Snow-chain clearance Speedometer calibration Headlight aim Bumper height Tire Pressure Monitoring System* NOTE When replacing a wheel, make sure the new one is the same as the original factory wheel in diameter, rim width, and offset (inset/outset)...
Categories
- Manuals Home
- Mazda CX-3 Owners Manual
- Mazda CX-3 Service Manual
- Key Battery Replacement
- Wrench Indicator Light
- Fuel Gauge
- New on site
- Most important about car
Anchor Bracket
Anchor brackets for securing child-restraint systems are equipped in the vehicle. Locate each anchor position using the illustration.
To install a child-restraint system, remove the head restraint. Always follow the instruction manual accompanying the child-restraint system.
Anchor bracket location
Use the indicated anchor bracket locations when installing a child-restraint system equipped with a tether.
