Mazda CX-3: Warning/Indicator Lights / Indicator Lights
These lights turn on or flash to notify the user of the system operation status or a system malfunction.
*1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an Authorized Mazda Dealer.
Warning Lights
These lights turn on or flash to notify the user of the system operation
status or a system
malfunction.
*1 The light turns on when the ignition is switched on for an
operation check, and turns off a few seconds later or
when the engine is started...
Wrench Indicator Light
When the ignition is switched ON, the
wrench indicator light turns on and then
turns off after a few seconds.
The wrench indicator light turns on when
the preset maintenance period arrives...
Other information:
Mazda CX-3 (2015-2026) Owner's Manual: How to use USB mode
This unit does not support a USB 3.0 device. In addition, other devices may not be supported depending on the model or OS version. Playback Switch the ignition to ACC or ON. Press the power/volume dial to turn the audio system on. Press the media button to switch to the USB mode and start playback...
Mazda CX-3 (2015-2026) Owner's Manual: Windshield Washer
Pull the lever toward you and hold it to spray washer fluid. NOTE If the windshield washer is turned on when the windshield wipers are not operating, the windshield wipers operate a few times. If the washer does not work, inspect the fluid level...
Categories
- Manuals Home
- Mazda CX-3 Owners Manual
- Mazda CX-3 Service Manual
- Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go function) Display Indication
- Engine Start Function When Key Battery is Dead
- Headlights
- New on site
- Most important about car
Floor Mat
We recommend the use of Genuine Mazda floor mats.
WARNING
Make sure the floor mats are hooked on the retention pins to prevent them from bunching up under the foot pedals: Using a floor mat that is not secured is dangerous as it will interfere with the accelerator and brake pedal operation, which could result in an accident.
Do not install two floor mats, one on top of the other, on the driver's side: Installing two floor mats, one on top of the other, on the driver's side is dangerous as the retention pins can only keep one floor mat from sliding forward. Loose floor mat(s) will interfere with the foot pedals and could result in an accident. If using an all-weather mat for winter use always remove the original floor mat.
