Mazda CX-3: Meters and Gauges / Fuel Gauge

Mazda CX-3 (2015-2026) Owner's Manual / When Driving / Instrument Cluster and Display / Meters and Gauges / Fuel Gauge

The fuel gauge shows approximately how much fuel is remaining in the tank when the ignition is switched ON. We recommend keeping the tank over 1/4 full.

Mazda CX-3. Fuel Gauge

If the low fuel warning light illuminates or the fuel level is very low, refuel as soon as possible.

If inconsistency in engine performance or stalling occurs due to low fuel level conditions, refuel the vehicle as soon as possible and add at least 10 L (2.7 US gal, 2.2 Imp gal) of fuel. Refer to Taking Action.

NOTE

After refueling, it may require some time for the indicator to stabilize. In addition, the indicator may deviate while driving on a slope or curve since the fuel moves in the tank.

The display indicating a quarter or less remaining fuel has more segments to show the remaining fuel level in greater detail.

The direction of the arrow Mazda CX-3. Fuel Gauge indicates that the fuel-filler lid is on the left side of the vehicle.

    Tachometer (Some models)

    The tachometer shows engine speed in thousands of revolutions per minute (rpm). CAUTION Do not run the engine with the tachometer needle in the RED ZONE...

    Dashboard Illumination

    (Without auto-light control) When the position lights are turned on with the ignition switched ON, the brightness of the dashboard illumination is dimmed...

    Other information:

    Mazda CX-3 (2015-2026) Owner's Manual: Vehicle Loading


    WARNING Do not tow a trailer with this vehicle: Towing a trailer with this vehicle is dangerous because it has not been designed to tow a trailer and doing so will affect the drive system which could result in vehicle damage. This section will guide you in the proper loading of your vehicle, to keep your loaded vehicle weight within its design rating capability...

    Mazda CX-3 (2015-2026) Owner's Manual: Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go function) Display Indication


    The MRCC with Stop & Go function setting status and operation conditions are indicated on the active driving display. If there is a problem with the MRCC with Stop & Go function system, MRCC with Stop & Go function warning light (amber) turns on...

    Categories

    Speedometer

    The speedometer indicates the speed of the vehicle.

    NOTE

    (Analog speedometer type)

    If a few seconds have elapsed after switching the ignition off, the needle may deviate. However, this does not indicate a problem.

    Speed Unit Selector (Digital Speedometer)(Some models)

    In some countries, you may have to change the speed units between km/h and mph.

    read more

     
    Copyright © 2026 www.macx3.net