Mazda CX-3: If Trouble Arises / Emergency Starting
Jump-Starting
Jump-starting is dangerous if done incorrectly. So follow the procedure
carefully. If you feel
unsure about jump-starting, we strongly recommend that you have a competent
service
technician do the work...
If the engine fails to start, it may be
flooded (excessive fuel in the engine).
Follow this procedure:
If the engine does not start within 5
seconds on the first try, wait 10
seconds and try again...
Other information:
Replacing the fuses on the vehicle's left
side
If the electrical system does not work, first
inspect the fuses on the vehicle's left side.
Make sure the ignition is switched off,
and other switches are off.
Open the fuse panel cover.
Pull the fuse straight out with the fuse
puller provided on the fuse block
located in the engine compartment...
This indicator light stays on for a few
seconds when the ignition is switched ON.
If the TCS or DSC is operating, the
indicator light flashes.
If the light stays on, the TCS, DSC or the
brake assist system may have a
malfunction and they may not operate
correctly...
Categories
We recommend the use of Genuine Mazda floor mats.
WARNING
Make sure the floor mats are hooked on the
retention pins to prevent them from
bunching up under the foot pedals:
Using a floor mat that is not secured is
dangerous as it will interfere with the
accelerator and brake pedal operation,
which could result in an accident.
Do not install two floor mats, one on top of
the other, on the driver's side:
Installing two floor mats, one on top of the
other, on the driver's side is dangerous as
the retention pins can only keep one floor
mat from sliding forward.
Loose floor mat(s) will interfere with the
foot pedals and could result in an accident.
If using an all-weather mat for winter use
always remove the original floor mat.

read more