Mazda CX-3: Cruise Control (Some models) / To Deactivate
When a cruising speed has been set (cruise set indication (white) is
displayed/cruise set indicator light (green) turns on)
Long-press the OFF/CAN switch or press
the OFF/CAN switch 2 times.
When a cruising speed has not been set (cruise main indication (white)
is displayed)
Press the OFF/CAN switch.
To temporarily cancel the system, use one
of these methods:
Slightly depress the brake pedal.
(Manual transaxle)
Depress the clutch pedal.
Press the OFF/CAN switch...
The Tire Pressure Monitoring System (TPMS) monitors the pressure for each
tire.
If tire pressure is too low in one or more tires, the system will inform the
driver via the
warning light in the instrument cluster and by the warning beep sound...
Other information:
The EPB equipment applies the parking
brake using an electric motor. When the parking brake is applied, the EPB switch
indicator light turns on.
WARNING
Do not drive the vehicle with the parking
brake applied: If the vehicle is driven with the parking
brake applied, the brake parts may
generate heat and the brake system may
not operate, leading to an accident...
The tachometer shows engine speed in
thousands of revolutions per minute (rpm).
CAUTION
Do not run the engine with the tachometer
needle in the RED ZONE.
This may cause severe engine damage.
Type A
Type B
NOTE
When the tachometer needle enters the
STRIPED ZONE, this indicates to the
driver that the gears should be shifted
before entering the RED ZONE...
Categories
The speedometer indicates the speed of the vehicle.
NOTE
(Analog speedometer type)
If a few seconds have elapsed after
switching the ignition off, the needle may
deviate. However, this does not indicate a
problem.
Speed Unit Selector (Digital Speedometer)(Some models)
In some countries, you may have to
change the speed units between km/h and
mph.
read more