Mazda CX-3: Engine Oil / Vehicle Engine Control Unit Reset Procedure

Mazda CX-3 (2015-2024) Owner's Manual / Maintenance and Care / Owner Maintenance / Engine Oil / Vehicle Engine Control Unit Reset Procedure

NOTE

This procedure is intended for vehicles with the engine oil flexible maintenance setting selected.

After replacing the engine oil, have a repair shop such as an Authorized Mazda Dealer perform the initialization (engine oil data resetting) of the recorded value. If the value recorded by the computer is not initialized, the wrench indicator light may not turn off or it may turn on earlier than normal.

NOTE

The initialization (engine oil data resetting) of the recorded value can be performed using the following procedure:

Switch the ignition OFF.
Switch the ignition ON with the selector pressed and continue pressing the selector for about 5 seconds until the master warning light flashes.
After the master warning light flashes for several seconds, the initialization is completed.

Recommended Oil

U.S.A., Canada, and Puerto Rico Use SAE 0W-20 engine oil. Mazda Genuine Oil is used in your Mazda vehicle. Mazda Genuine 0W-20 Oil is required to achieve optimum fuel economy...

Inspecting Engine Oil Level

Be sure the vehicle is on a level surface. Warm up the engine to normal operating temperature. Turn it off and wait at least 5 minutes for the oil to return to the oil pan...

Other information:

Mazda CX-3 (2015-2024) Owner's Manual: Replacing Windshield Wiper Blades

When the wipers no longer clean well, the blades are probably worn or cracked. Replace them. CAUTION To prevent damage to the wiper arms and other components, do not try to sweep the wiper arm by hand. NOTE When raising both windshield wiper arms, raise the driver's side wiper arm first...

Mazda CX-3 (2015-2024) Owner's Manual: Wiper Blades

CAUTION Hot waxes applied by automatic car washers have been known to affect the wiper's ability to clean windows. To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them. When the wiper lever is in the AUTO position and the ignition is switched ON, the wipers may move automatically in the following cases: If the windshield above the rain sensor is touched...

Categories

Child-Restraint System Types

In this owner's manual, explanation of child-restraint systems is provided for the following three types of popular child-restraint systems: infant seat, child seat, booster seat.

NOTE

Installation position is determined by the type of child-restraint system. Always read the manufacturer's instructions and this owner's manual carefully. Due to variations in the design of child-restraint systems, vehicle seats and seat belts, all child-restraint systems may not fit all seating positions. Before purchasing a child-restraint system, it should be tested in the specific vehicle seating position (or positions) where it is intended to be used. If a previously purchased child-restraint system does not fit, you may need to purchase a different one that will.