Mazda CX-3: Switches and Controls / Rear Window Wiper and Washer
The ignition must be switched ON to use
the wiper.
Rear Window Wiper

Turn the wiper on by turning the rear
wiper/washer switch.

Rear Window Washer
To spray washer fluid, turn the rear wiper/
washer switch to either of the position.
After the switch is released, the washer
will stop.
If the washer does not work, inspect the
fluid level. If the fluid level
is normal and the washer still does not
work, consult an Authorized Mazda
Dealer.
Pull the lever toward you and hold it to
spray washer fluid.
NOTE
If the windshield washer is turned on when
the windshield wipers are not operating,
the windshield wipers operate a few times...
The rear window defogger clears fog from
the rear window.
The ignition must be switched ON to use
the defogger.
Press the switch to turn on the rear
window defogger...
Other information:
Set the mode selector dial to the
position and turn the fan control dial to the
desired speed.
In this position, the outside air position is
automatically selected, and when the fan
control dial is ON, the air conditioner
automatically turns on...
For optimum protection, the driver and
front passenger seat belts are equipped
with pretensioner and load limiting
systems. For both these systems to work
properly you must wear the seat belt
properly.
Pretensioners:
When a collision is detected, the
pretensioners deploy simultaneously with
the air bags...
Categories

NOTE
The headlights turn on/off by operating
the transmitter. Refer to Leaving Home
Light.
(With theft-deterrent system)
The hazard
warning lights flash when
the theft-deterrent system is armed or
turned off.
Refer to Theft-Deterrent System.
(With the advanced keyless function)
read more