Mazda CX-3: Transaxle Ranges / Shift Position Indication
The selector position is indicated when the ignition is switched ON.
Gear position indication
In manual shift mode, the “M” of the shift position indication illuminates and the numeral for the selected gear is displayed.
Transaxle Ranges
The shift position indication in the
instrument cluster illuminates.
Refer to Warning/Indicator Lights.
The selector lever must be in P or N
position to operate the starter...
Active Adaptive Shift (AAS)
Active Adaptive Shift (AAS)
automatically controls the transaxle shift
points to best suit the road conditions and
driver input. This improves driving feel...
Other information:
Mazda CX-3 (2015-2023) Owner's Manual: Vehicle Engine Control Unit Reset Procedure
NOTE This procedure is intended for vehicles with the engine oil flexible maintenance setting selected. After replacing the engine oil, have a repair shop such as an Authorized Mazda Dealer perform the initialization (engine oil data resetting) of the recorded value...
Mazda CX-3 (2015-2023) Owner's Manual: Radar Sensors (Rear) (Some models)
Your vehicle is equipped with radar sensors (rear). The following systems also use the radar sensors (rear). Blind Spot Monitoring (BSM) Rear Cross Traffic Alert (RCTA) The radar sensors (rear) function by detecting the radio waves reflected off a vehicle approaching from the rear or an obstruction sent from the radar sensor...
Categories
- Manuals Home
- Mazda CX-3 Owners Manual
- Mazda CX-3 Service Manual
- Trip Computer and INFO Switch (Some models)
- Adjusting the Driver's Seat
- Engine Start Function When Key Battery is Dead
- New on site
- Most important about car
Floor Mat
We recommend the use of Genuine Mazda floor mats.
WARNING
Make sure the floor mats are hooked on the retention pins to prevent them from bunching up under the foot pedals: Using a floor mat that is not secured is dangerous as it will interfere with the accelerator and brake pedal operation, which could result in an accident.
Do not install two floor mats, one on top of the other, on the driver's side: Installing two floor mats, one on top of the other, on the driver's side is dangerous as the retention pins can only keep one floor mat from sliding forward. Loose floor mat(s) will interfere with the foot pedals and could result in an accident. If using an all-weather mat for winter use always remove the original floor mat.
