Mazda CX-3: Owner Maintenance / Fuses

Mazda CX-3 (2015-2026) Owner's Manual / Maintenance and Care / Owner Maintenance / Fuses

Your vehicle's electrical system is protected by fuses.

If any lights, accessories, or controls do not work, inspect the appropriate circuit protector. If a fuse has blown, the inside element will be melted.

If the same fuse blows again, avoid using that system and consult an Authorized Mazda Dealer as soon as possible.

Replacing Interior Light Bulbs

Overhead lights (Front)/Map lights, Overhead lights (Rear) Wrap a small flathead screwdriver with a soft cloth to prevent damage to the lens, and then remove the lens by carefully prying on the edge of the lens with the flathead screwdriver...

Fuse Replacement

Replacing the fuses on the vehicle's left side If the electrical system does not work, first inspect the fuses on the vehicle's left side. Make sure the ignition is switched off, and other switches are off...

Other information:

Mazda CX-3 (2015-2026) Owner's Manual: Height Adjustment

Adjust the head restraint so that the center is even with the top of the passenger's ears. To raise a head restraint, pull it up to the desired position. To lower the head restraint, press the stop-catch release, then push the head restraint down...

Mazda CX-3 (2015-2026) Owner's Manual: Parking in an Emergency

The hazard warning lights should always be used when you stop on or near a roadway in an emergency. The hazard warning lights warn other drivers that your vehicle is a traffic hazard and that they must take extreme caution when near it. Depress the hazard warning flasher and all the turn signals will flash...

Categories

Child-Restraint System Types

In this owner's manual, explanation of child-restraint systems is provided for the following three types of popular child-restraint systems: infant seat, child seat, booster seat.

NOTE

Installation position is determined by the type of child-restraint system. Always read the manufacturer's instructions and this owner's manual carefully. Due to variations in the design of child-restraint systems, vehicle seats and seat belts, all child-restraint systems may not fit all seating positions. Before purchasing a child-restraint system, it should be tested in the specific vehicle seating position (or positions) where it is intended to be used. If a previously purchased child-restraint system does not fit, you may need to purchase a different one that will.