Mazda CX-3: Fuses / Fuse Replacement
Replacing the fuses on the vehicle's left side
If the electrical system does not work, first inspect the fuses on the vehicle's left side.
- Make sure the ignition is switched off, and other switches are off.
- Open the fuse panel cover.
- Pull the fuse straight out with the fuse
puller provided on the fuse block
located in the engine compartment.
- Inspect the fuse and replace it if it is
blown.
- Insert a new fuse of the same
amperage rating, and make sure it fits
tightly. If it does not fit tightly, have an
expert install it. We recommend an
Authorized Mazda Dealer.
If you have no spare fuses, borrow one
of the same rating from a circuit not
essential to vehicle operation, such as
the AUDIO or OUTLET circuit.
CAUTION
Always replace a fuse with a genuine Mazda fuse or equivalent of the same rating. Otherwise you may damage the electric system.
- Reinstall the cover and make sure that it is securely installed.
Replacing the fuses under the hood
If the headlights or other electrical components do not work and the fuses in the cabin are normal, inspect the fuse block under the hood. If a fuse is blown, it must be replaced. Follow these steps:
- Make sure the ignition is switched off, and other switches are off.
- Remove the fuse block cover.
- If any fuse but the MAIN fuse is
blown, replace it with a new one of the
same amperage rating.
WARNING
Do not replace the main fuse by yourself. Have an Authorized Mazda Dealer perform the replacement: Replacing the fuse by yourself is dangerous because the MAIN fuse is a high current fuse. Incorrect replacement could cause an electrical shock or a short circuit resulting in a fire.
- Reinstall the cover and make sure that it is securely installed.
Fuses
Your vehicle's electrical system is
protected by fuses.
If any lights, accessories, or controls do
not work, inspect the appropriate circuit
protector...
Other information:
Mazda CX-3 (2015-2026) Owner's Manual: Tilt/Slide Operation
The moonroof can be opened or closed electrically only when the ignition is switched ON. Before leaving the vehicle or washing your Mazda, make sure the moonroof is completely closed so that water does not get inside the cabin area. After washing your Mazda or after it rains, wipe the water off the moonroof before operating it to avoid water penetration which could cause rust and water damage to your headliner...
Mazda CX-3 (2015-2026) Owner's Manual: KEYS
WARNING Do not leave the key in your vehicle with children and keep them in a place where your children will not find or play with them: Leaving children in a vehicle with the key is dangerous. This could result in someone being badly injured or even killed...
Categories
- Manuals Home
- Mazda CX-3 Owners Manual
- Mazda CX-3 Service Manual
- TCS OFF Switch
- Adjusting the Driver's Seat
- Trip Computer and INFO Switch (Some models)
- New on site
- Most important about car
Speedometer
The speedometer indicates the speed of the vehicle.
NOTE
(Analog speedometer type)
If a few seconds have elapsed after switching the ignition off, the needle may deviate. However, this does not indicate a problem.
Speed Unit Selector (Digital Speedometer)(Some models)
In some countries, you may have to change the speed units between km/h and mph.
