Mazda CX-3: Theft-Deterrent System (Some models) / Operation
System triggering conditions
The horn sounds intermittently and the
hazard warning lights flash for about 30
seconds when the system is triggered by
any one of the following:
- Unlocking a door with the auxiliary key,
door lock switch, or an inside door-lock
knob.
- Forcing open a door, the hood or the
liftgate.
- Opening the hood by operating the hood
release handle.
- Switching the ignition ON without using
the push button start.
If the system is triggered again, the lights
and horn will activate until the driver's
door or the liftgate is unlocked with the
transmitter.
(With the advanced keyless function)
The lights and horn can also be
deactivated by pressing the request switch
on a door.
NOTE
- The liftgate does not open while the
theft-deterrent system is operating.
- If the battery goes dead while the
theft-deterrent system is armed, the horn
will activate and the hazard warning
lights will flash when the battery is
charged or replaced.
If the theft-deterrent system detects an
inappropriate entry into the vehicle, which
could result in the vehicle or its contents
being stolen, the alarm alerts the
surrounding area of an abnormality by
sounding the horn and flashing the hazard
warning lights...
Close the windows and the moonroof*
securely.
Switch the ignition OFF.
Make sure the hood, the doors, and the
liftgate are closed.
Press the lock button on the transmitter
or lock the driver's door from the
outside with the auxiliary key...
Other information:
The RCTA system is designed to assist the driver in checking the area to the
rear of the
vehicle on both sides while the vehicle is reversing by alerting the driver to
the presence of
vehicles approaching the rear of the vehicle.
The RCTA system detects vehicles approaching from the rear left and right sides
of the
vehicle, and the rear of the vehicle while the vehicle is being reversed out of
a parking
space, and notifies the driver of possible danger using the Blind Spot
Monitoring (BSM)
warning indicator lights and the warning buzzer...
The MRCC with Stop & Go function setting status and operation conditions are
indicated
on the active driving display.
If there is a problem with the MRCC with Stop & Go function system, MRCC with
Stop &
Go function warning light (amber) turns on...
Categories
The speedometer indicates the speed of the vehicle.
NOTE
(Analog speedometer type)
If a few seconds have elapsed after
switching the ignition off, the needle may
deviate. However, this does not indicate a
problem.
Speed Unit Selector (Digital Speedometer)(Some models)
In some countries, you may have to
change the speed units between km/h and
mph.
read more