Mazda CX-3: Manual Type / Cooling
- Set the mode selector dial to the
position.
- Set the temperature control dial to the
cold position.
- Set the fan control dial to the desired
speed.
- Turn on the air conditioner by pressing
the A/C switch.
- After cooling begins, adjust the fan
control dial and temperature control
dial as needed to maintain maximum
comfort.
CAUTION
If the air conditioner is used while driving
up long hills or in heavy traffic, monitor the
high engine coolant temperature warning
light to see if it is illuminated or flashing.
The air conditioner may cause engine
overheating. If the warning light is
illuminated or flashing, turn the air
conditioner off.
NOTE
- (Type A)
- When maximum cooling is desired, set
the temperature control dial to the
extreme cold position and set the air
intake selector to the recirculated air
position, then turn the fan control dial
fully clockwise.
- (Type B)
- When maximum cooling is desired, set
the temperature control dial to the
extreme cold position and set the air
intake selector to the recirculated air
position, then set the fan control dial to
position 4.
- If warmer air is desired at floor level,
set the mode selector dial at the
position and adjust the
temperature
control dial to maintain maximum
comfort.
- The air to the floor is warmer than air
to the face (except when the temperature
control dial is set at the extreme hot or
cold position).
Set the mode selector dial to the
position.
(Type A)Set the air intake selector to the outside
air position.
(Type B)
Set the air intake selector to the
position...
Set the mode selector dial to the
position.
(Type A)Set the air intake selector to the outside
air position.
(Type B)
Set the air intake selector to the
position...
Other information:
U.S.A. and Puerto Rico residents - Severe driving conditions maintenance
interval
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if
necessary.
R: Replace
L: Lubricate
C: Clean
T: Tighten
D: Drain
Remarks:
*1 If the vehicle is operated in very dusty or sandy areas, clean and if
necessary, replace the air filter more often
than the recommended intervals...
How you operate your Mazda determines
how far it will travel on a tank of fuel. Use
these suggestions to help save fuel and
reduce CO2.
Avoid long warm-ups. Once the engine
runs smoothly, begin driving.
Avoid fast starts.
Drive at lower speeds...
Categories
In this owner's manual, explanation of
child-restraint systems is provided for the
following three types of popular
child-restraint systems: infant seat, child
seat, booster seat.
NOTE
Installation position is determined by
the type of child-restraint system.
Always read the manufacturer's
instructions and this owner's manual
carefully.
Due to variations in the design of
child-restraint systems, vehicle seats
and seat belts, all child-restraint systems
may not fit all seating positions. Before
purchasing a child-restraint system, it
should be tested in the specific vehicle
seating position (or positions) where it
is intended to be used. If a previously
purchased child-restraint system does
not fit, you may need to purchase a
different one that will.
read more