Mazda CX-3: Bluetooth® Audio / Switching to Bluetooth® audio mode
To listen to music or voice audio recorded to a Bluetooth® audio device,
switch to the
Bluetooth® audio mode to operate the audio device using the audio system control
panel.
Any Bluetooth® audio device must be paired to the vehicle's Bluetooth® unit
before it can
be used.
Refer to Bluetooth® Preparation (Type B).
- Turn on the Bluetooth® audio device's power.
- Switch the ignition to ACC or ON.
- Select the
icon on the
home screen to display the Entertainment screen.
- When
is selected, switches
to the Bluetooth® audio mode to begin playback.
Applicable Bluetooth® specification (Recommended)
Ver. 1.1/1.2/2.0 + EDR/2.1 + EDR/3.0
(conformity)
Response profile
A2DP (Advanced Audio Distribution
Profile) Ver...
To listen to a Bluetooth® audio device over the vehicle's speaker system,
switch the mode to
Bluetooth® audio mode. (Refer to “Switching to Bluetooth® audio mode”)
After switching to the Bluetooth® audio mode, the following icons are
displayed in the
lower part of the display...
Other information:
To temporarily cancel the system, use one
of these methods:
Slightly depress the brake pedal.
(Manual transaxle)
Depress the clutch pedal.
Press the OFF/CAN switch.
If the switch is pressed when the
vehicle speed is 25 km/h (16 mph) or higher, the system reverts to the
previously
set speed...
U.S.A. and Puerto Rico residents - Engine oil flexible maintenance
interval
Use when the maintenance monitor for “Oil Change” is set to “Flexible”.
For details,
see maintenance monitor.
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if
necessary...
Categories
The speedometer indicates the speed of the vehicle.
NOTE
(Analog speedometer type)
If a few seconds have elapsed after
switching the ignition off, the needle may
deviate. However, this does not indicate a
problem.
Speed Unit Selector (Digital Speedometer)(Some models)
In some countries, you may have to
change the speed units between km/h and
mph.
read more