Mazda CX-3: If a Warning Light Turns On or Flashes / Taking Action
Take the appropriate action and verify that the warning light turns off.




Tire Pressure Monitoring System Warning Light (Turns on)(Some models)

Take the appropriate action and verify that the warning light turns off.


KEY Warning Light
Take the appropriate action and verify that the warning light turns off.

If any of the following warning lights or the indicator light turns
on/flashes, the system may
have a malfunction. Contact an Authorized Mazda Dealer to have your vehicle
inspected...
If a message is displayed in the center display (Type B audio), take
appropriate action (in a
calm manner) according to the displayed message.
(Display example)
Stop Vehicle in Safe Place Immediately
If the following messages are displayed in the center display (Type B audio),
a vehicle
system may be malfunctioning...
Other information:
The front seats are electrically heated. The
ignition must be switched ON.
Press the seat warmer switch while the
ignition is switched ON to operate the seat
warmer. The indicator lights turn on to
indicate that the seat warmer is operating.
The mode changes as follows each time
the seat warmer switch is pressed...
When the warning light flashes, there may
be a system malfunction. Consult an
Authorized Mazda Dealer.
A system error activation may occur in the
following cases:
When there is equipment or a device
near the vehicle using the same radio
frequency as that of the tire pressure
sensors...
Categories
In this owner's manual, explanation of
child-restraint systems is provided for the
following three types of popular
child-restraint systems: infant seat, child
seat, booster seat.
NOTE
Installation position is determined by
the type of child-restraint system.
Always read the manufacturer's
instructions and this owner's manual
carefully.
Due to variations in the design of
child-restraint systems, vehicle seats
and seat belts, all child-restraint systems
may not fit all seating positions. Before
purchasing a child-restraint system, it
should be tested in the specific vehicle
seating position (or positions) where it
is intended to be used. If a previously
purchased child-restraint system does
not fit, you may need to purchase a
different one that will.
read more